The outdoor UPS system has good protection function: such as heat
insulation,dustproof, damp proof, waterproof etc.
Outdoor communication/network equipment is often used in the
corners of cities, remote roads and mountainous areas, where the
environment is harsh, such as high temperature (50℃), serious
(minus 40℃), dust, high humidity and rain, acid fog erosion, etc.,
and the quality of the power grid is very poor (voltage is below
160V or above 260V for a long time, and frequency changes
abnormally). Therefore, the outdoor UPS can meet the harsh
temperature conditions, humidity conditions, air conditions, and
meet the requirements of outdoor power grid.
● The advanced PFC technology, improves the input power factor
close to utility, raises the power efficiency, removes the harmonic
noise from UPS to utility, lowers UPS operational cost, it’s really
a good environmental protection power supply.
● If main power blackout, ups will transfer to backup mode to
supply loads. When battery voltage is low, ups would protect itself
and shuts down. When the main power recovers, the UPS would check
the main power itself, if the main power is also normal, ups would
turn on automatically to supply loads; if main power is abnormal,
UPS would just turn on charger to charge the battery until the main
power is normal.Smart management function.
● Advanced voltage compensation technique, makes the input voltage
range from 115VAC to 295VAC, using batteries less, enhancing the
adaptability against the bad power condition.
● Advanced wide input frequency technique, makes the input
frequency range from 45Hz to 55Hz, compatible with generator under
variable circumstance.
● DC start function, when there is no main power; UPS can be turned
on by battery, to meet the user’s emergency needs. The cold start
function is quite strong. UPS can be cold started on full load
situation.
Specification
Model | 1KVA | 2KVA | 3KVA | 6KVA | 10KVA |
Range voltage | 220/230/240VAC |
Frequency | 50Hz/62Hz |
Input |
Voltage range | 115~295VAC(±3VAC) | 176~297VAC(±3VAC) |
Frequency Range | 50Hz (46~54 Hz) ; 60Hz (56~64 Hz) |
Soft Start | 0~100% 5sec |
Power factor | 0.98 |
Output |
Voltage Precision | 220/230/240VAC(1±2%)AC |
Frequency Precision | 50Hz/62Hz±0.05Hz |
Power factor | 0.7/0.8(optional) standard 0.7 |
Wave Distortion | Linear load<3% Non-linear load<6% |
Overload capability | Overload(110~150%)for 30 seconds,then automatically transfer to
bypass.When load is normal,it can automatically transfer to normal
mode |
Crest Factor | 3:01 |
Transfer time | 0ms (AC to DC) |
battery | 36VDC | 72VDC | 96VDC | 240VDC | 240VDC |
Charging current | 4A/8A(optional) | 4A/8A(optional) | 4A/8A(optional) | 4.2A | 4.2A |
Internal Battery Caoacity | (38/65/80/100AH) optional |
Panel display |
LED | Load level/Battery level ,Battery indicator,Utility power,Inverter
,Bypass,Overload ,Fault |
Communications |
Communications interface | RS232 SNMP card(optional) |
Work Environment |
Temperature | -40~55ºC |
Humidity | 0~95%(Non-condensing |
Storage Temperature | -25ºC~55ºC |
Elevation | <1500m |
Physical Characteristics |
Weight(KG)N.W | 85 | 125 | 125 | 150 | 150 |
Dimensions:(WxDxH)mm | 613*640*954 | 650*753*1227 | 650*753*1227 | 940*940*1770 | 940*940*17 |
